How To Solder Copper Wire At Home

Begin by laying out all the items containing copper wire that you wish to solder.

How to solder copper wire at home. The broader diameter solder 062 is better for soldering bigger joints faster but it can be difficult to solder tiny joints. When working with large amounts of copper wire outside of electronics it may be beneficial to apply solder flux either purchased or made at home from rosin and alcohol before proceeding. Or else just place the soldered tip of wire on a presoldered solder pad on a pcb apply heat.

In mains wiring a lot of engineering is done to assure were not wasting copper. Plug in your soldering iron to let it heat up and put on all the necessary safety gear. Focus the flame over the copper gently shaking the crucible to mix the wire and redistribute pieces that are still whole.

Touch the tip of the soldering iron to the copper wires. Your solder will be applied opposite from the iron on top of the wire. Metalsmiths who are using a kiln should heat the furnace hot enough to melt the copper.

This will heat the wire to allow your solder to melt. Coat the cleaned wire with flux. Remove the soldering iron and wait a few seconds to let the soldered connection cool and harden.

Keep the iron in place and touch the solder to the wire until its fully coated. Use heat shrink to. First place the solder on the tip to allow for melting.

Heat the copper not the solder using a suitable heat source gun or torch The copper needs to be hot enough to melt the solder so that it flows. Apply the tip of the soldering iron to the wet sponge to make the tip clean. Handle the crucible with tongs when placing the wire in or taking it out of the kiln.