How To Use Bosch Router Table As A Jointer

Thank for you idea own dimensions need use buut newererming idea have same i like looking internet lot tool ideas and make some.

How to use bosch router table as a jointer. Using Router tables as a jointer. It is designed to hold inserts for various bit sizes. The rigid router fence will keep the laminate from flexing.

Ive watched a few videos and have done some reading on the procedure and it seems pretty straight forward but each run of my test board leave inconsistencies. Hi - Just purchased a used Bosch RA1181 benchtop table and installed a Bosch 1617 router. Place your laminate piece at the left-hand edge of the bit-clearance notch in the router table fence.

The Bosch RA1181 Benchtop Router Table provides a premium large work surface for woodworking and routing. C-clamp the infeed side of your fence and you are ready to rout. Straight edges on boards or plywood.

As you get into making cabinets at some point you may wish to get a smaller trim router such as the Bosch Colt or DeWalt 611. The Bosch fixed base can be used as a lift in a table. Make sure the insert plate holding the router tool is properly attached and sits in flush with a router table surface.

I planned on using this to edge joint boards. I would use a straight bit because the cutting edge is one solid edge. Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer laid on its side.

The router bit leaves a vertical surface that makes it simple to make a right seam when you are gluing wood which means edging to plywood. The books on routers and other topics are really useful for understanding some of the arcane woodworking terms associated with this must-have tool. Yes a very narrow jointer good for edge joining but too narrow for face jointing.