How To Make Wire Soldering Iron

There are advantages to using a soldering iron like this.

How to make wire soldering iron. Once youre done use electrical tape to cover the two wires and fasten them together to form one block section of the base. Part 1 and part 2. Grind off the flat head.

This video shows how to make a simple soldering iron using easily available materials. The heat will transfer from the iron and into the wires so the flux turns into a liquid. It involves using hot glue to position the battery box to the bases two-block sections.

10 Ways on How to Make Soldering Iron Without Nichrome Wire 1. The solder head a piece of thick copper wire. So when you are trying to make the soldering iron without nichrome wire you can also try the following tutorial as its quite similar to the one mentioned above.

As shown in fig no. Do it as shown in the photo. Keep the iron in place and touch the solder to the wire until its fully coated.

Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4. Drive the square end of the spike about half way into the pipe you might have to drive in some metal shims like nails into the pipe to keep the spike from wobbling. Now you can try using it and see if it works for you.

Repeat this process on the other wire. Copper wire is a cheaper option. Hold it on the wire for 3-4 seconds.