How To Make Soldering Iron With Copper Wire

When doing this you should take one block of wood and consequently make a hole on its top side which should be the smallest end.

How to make soldering iron with copper wire. Slide the iron to the end of the connection and then to the other end. The soldering iron is then dipped in flux and then solder is applied on the tip. Materials you will need.

Materials you will need. Clean the tip of the soldering iron and tin it with solder. You cant solder it with a backing in place just like you wouldnt solder a wire without stripping some of the insulation.

Your solder will be applied opposite from the iron on top of the wire. Ad Quality Solder Wire Drawing Machine. Alternatively use a thin wire to apply flux as the brush may spread too much flux.

Then make two more bends near the center or loop of the first bend as shown in the video so the wire. Apply a drop of solder flux on top of the wire connection. First twist the stranded wire in your fingers so that theyre bundled neatly and tightly in one direction.

This soldering iron consists of a copper bit thats riveted to steel which is then fitted into a woodenplastic handle for insulation. Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4. Touch the soldering iron to the wire and run enough solder to it to coat the wire.

Touch the tip of the soldering iron to the copper wires. Add the proper amount of solder. Cleanliness is a must for good solder joints.