How To Use Piping Tips Without Coupler

Open your piping bag and put it one hand and then using your other hand scoop the icing into the piping bag and then gently squeeze the icing down the piping bag until it just begins to come through the nozzle and then you can start piping.

How to use piping tips without coupler. Next step is to fit the piping tip. You can use icing tips with no couplers just push the tip inside the bag and cut the end off allowing just the end of the tip to stick out. However couplers are needed if youre planning to use more than one tip with your piping bag.

On that note if you like the frosting mixture in your bag but want to change tips and you dont have a large coupler heres what you can do. To change tip just remove the outer bag change the nozzle put it back again and you are ready to pipe again. Next prepare your different icing colors in smaller bags without tips.

The bag will keep it nice and secure. Once the frosting is in the piping bag use your spatula to further press the frosting down into the bag. Fat daddio as large tips made of polycarbonate that have an edge on purpose they dont require couplers.

The first and most obvious way to connect PVC pipe and fittings without using glue is to simply push the parts together. If youre using a tip with no coupler I use this method when Im using a larger tip for frosting cupcakes just push the tip into the bag and trim the piping bag so that about half of the tip sticks out. Pipe all the way around in a circular motion and finish the rosette at the highest point or at 12 oclock if using a clock as a reference point.

One of the pieces goes inside the bag before you fill it and the other piece twists on the outside to hold the tip in place. Wilton piping tips do not require the use of a coupler. You can also use a coupler if you want to give your tip a little more stability.

Posted by Zurynee at 1251 AM. Push the coupler back down through this hole until the hole lines up with the beginning of the couplers threaded lines. If you dont want to buy a coupler you can simply make your own by using two different piping bags.