How To Tin Soldering Iron Tips

Keep trying to melt the solder on the paste wet tip as you must tin it before it becomes too hot that it burns out the paste.

How to tin soldering iron tips. Thats how you can tin your new soldering iron. Apply liquid flux to the working area of the tip and submerse it into the molten solder in a smooth even motion. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough.

Start by plugging the soldering iron in and allowing it to heat up. Soak the sponge using the water squeeze it out a little then use it to clean the tip of the soldering iron. With the iron tip cold use a polishing bar.

Wipe OFF the solder on the Cleaning Sponge or Copper Wool. Then of course you need to tin the iron again which means adding a fair amount of solder and letting it sit for a few minutes before wiping it clean. ANd of course if you dont tin the tip in the first place again letting it warm up and then melting solder on it so it covers the tip and then.

Pliers will keep it at the proper place as well as tighten the windings. That is it would be the antagonist to tin soldering ironAnd although removing a weld can also be done in other more rudimentary ways with this gadget you will do it more precisely and quickly. Add Tip Ask Question Comment Download Step 4.

You will want to tin your tips when you first purchase them before use when the iron is sitting idle in the holder during use and when you finish soldering before you pack your tips for storage. Turn the solder pot on and allow it to achieve the desired temperature. Melt some good quality of solder wire on the Tip.

If you over-clean the tip after use and then leave the iron in the holder there is a slight risk of oxide on the iron plating - I always clean and tin the tip immediately before using and leave any residual solder on the tip while its in the holder. A polyurethane foam bar with embedded abrasives which is used to polish the working end of the tip to remove surface oxides. Dont use a synthetic sponge.