How To Solder Wires Correctly

And then hold the soldering iron for 3-5 sec unless the Solder is melted.

How to solder wires correctly. Soldering Two Wires. This process should melt the solder and coat both wires evenly. While there are probably a thousand different ways to do this there are also a thousand different ways to do it wrong.

Holding the iron below the wires allows the heat to travel upwards while gravity pulls the molten solder down. Sand the bare ends with an emery cloth knife. You may select the dipping time as per your litz wire AWG size as below table.

Also numerous good and bad joint pics. Because it basically has no temperature control and such soldering irons typically have the tip at really high temperatures like 400-500 degrees Celsius Due to this high temperature the flux inside the solder wire you use has practically no time to turn into liquid and flow over the area you want to solder and do its work clean the area make it ready for the actual solder to work and glue the two. Touch the tip of the soldering iron to the wires and keep it there.

Hold the two tinned wires on top of each other and touch the soldering iron to both wires. When the Solder is melted it will automatically create a strong bond between the connector and wire. If you want to join two wires with solder the first thing you should do is to tin the two wires.

Instead allow the iron to heat the wire to the point that it melts the solder. Hold the two tinned wires on top of each other and touch the soldering iron to both wiresHow to solder wires together correctly like a proIf you want to join two wires with solder the first thing you should do is to tin the two wires. Making a soldering litz wire is of as following.

Slide the iron to the end of the connection and then to the other end. Install the ends of the wires into the holes on the board or into the sockets of the components in other cases. Move the iron to the opposite bottom side of the connection and repeat the same technique.