How To Solder Wire Properly

And allow the solder to melt.

How to solder wire properly. Set the iron to the solders temperature range. Take your solder and touch at the point where the iron and wire make contact. The solder wire is then applied to the front side of the terminal but is not brought into contact with the iron See figure 1.

How to Solder Neatly and Properly. How to Solder Wires. So soldering of two overlapping wires.

Soldering Two Wires. This will create a heat bridge in which from the soldering iron heating up the wires the wires will then cause the solder to melt on them. Place the tip of the iron on the wire and let it heat for a few seconds.

Wrap one or two inches of solder around the tip while the iron is cold. When the solder melts into the terminal and wire the joint is properly soldered. Once the wires are hot enough there will be smokes as a sign of heated wires attach the solder on the heated location.

While there are probably a thousand different ways to do this there are also a thousand different ways to do it wrong. Cut the wires to the. Touch the tip of the soldering iron to the wires and keep it there.

Once youve got it figured out and have done it a couple of times its very easy to do this in a matter of seconds whenever you need to. Now that your wire has been properly tinned it can be soldered to the sensor the same way as the connector below. Neat and Proper soldering technique and quality of solder are the lifeline of any PCB AssemblyThe secret to solder neatly and professionally is to use the right professional tool and good quality of consumables wire paste bar fluxIn electronics PCB manufacturing assembly and rework the metals to be joined are the leads of the electronic.