How To Solder Solid Copper Wire
A jumper is a stiff sometimes bare wire that bridges across some traces on the top or bottom of the board.
How to solder solid copper wire. Plug the soldering guniron into an electrical outlet and allow it to heat up for about three to five minutes. The inside of your copper and brass fittings will need to be cleaned just like the outside of the pipe you want to solder. How to Solder Stranded Wire to Solid Wire.
Ad Safe Trading Solder Wire Drawing Machine on Leading B2B Platform. Whilst waiting for the iron to heat take a sponge soak it in some cold water and wring it out so that it is damp. Second crimp the terminal onto the wire.
This will heat the wire to allow your solder to melt. Cut the excess of solid wire at the point where the first stranded twist starts. Also tin the PCB at the joint.
AND USE NON-CORROSIVE FLUX. Or a bit of steel wool or fine-grit sandpaper will work in a pinch. Ideally you should make sure the solder melts the strands of the two copper wires fusing the connection.
Hold the solder to the joint you are trying to solder. Ad Wholesale Mobile Accessories Parts Electronics With 12 years Experienced Supplier. Plug the soldering guniron into an electrical outlet and allow it to heat up for about three to five minutes.
Slip the copper wire under the jumper and bend the wire over the jumper so the connection iss snug. Bend the solid wire back. Place tip of soldering iron at the top of the connection and solder wires.