How To Solder Car Stereo Wires

If the solder does not flow through more heat will be required.

How to solder car stereo wires. Soldering is a bit more difficult your using a soldering iron that gets extremely hot to melt led free solder onto your wiring connection. The third twisted one made from the shield is for common. Slide the existing wire into the open side of the connector then put the end of the wire you wish to connect to it into the other side.

Make sure you are soldering correctly ground left and right. Cut strip the wire at least 12 length of bare wire is needed. Then heat them with the soldering iron and touch the solder to the wire after you heat it.

Using heatshrink will keep the joint from flexing. I promise this is easier than it sounds. Without moving it let the joint cool.

Crimping connectors and soldering adds resistance and more spots for corrosion to happen. EASY- How to solder your car stereo wires. To solder car speaker wires first plug the soldering iron into a power source.

Insert the wire into the small holes in the speaker wire tabs. You get the two wires together and then solder them to make a good connection. This wire will connect to the red wire on the stereo harness.

After a few moments apply solder until it flows and covers the hole wire and tab near the speaker wire. If you want to get it done right use a soldering iron and some flux with it. Touch the red meter probe to the wire you are testing with the ignition in the accessory position.