How To Solder Bass Guitar Wires

Often a novice will solder a wire from the jack sleeve to the back of the nearest pot and rely on the thin foil shield on the back of the pickguard in a Strat style guitar or possibly the shielding paint on the inside of the control cavity to carry the ground to the other pots and switches.

How to solder bass guitar wires. Get a custom drawn guitar or bass wiring diagram designed to your specifications for any type of pickups switching and controls and options. Add the Tone control by soldering a wire from Tab 1 of the Volume control to Tab 2 of the Tone control. Too much exposed wire can contact ground wires shielded pickup wires or hot wires.

Soldering is accomplished by quickly heating the metal parts to be joined and then applying solder to the mating surfaces. If a hot or ground wire is disconnected simply cut the wire back half a centimeter strip the shielding tin the exposed wire insert the exposed tip into the jacks terminal and apply a dot of solder over the terminal to seal the connection. Pack of four 4 solder lug washers.

It will quickly soak into the strands of the wire. Remove the tip of the soldering iron and the solder placing the soldering iron on its holder to prevent burns to the work table. Another thing that you will locate a circuit diagram would be traces.

The next important part is the shape of the soldering tip. Use to ground electric guitar and bass volume and tone pots switches and other parts for a clean and professional wiring job. This wire is usually soldered to a volume or tone control casing and Balance Control.

Fits CTS Bourns Fender Gibson Alpha and other pots with 38 diameter shafts. As far as size we recommend a 032 diameter solder for guitar work. For beginners I recommend a chisel tip pictured.

It will act as a heatsink to. Be sure to trim back any excess wire or solder that might touch the cable upon entry. Twist the strands together apply the iron to the wire and then when its hot enough take a little solder to the wire as well.