How To Solder 3 Wires Together

Heat the joint not the solder.

How to solder 3 wires together. Keep the iron in place and continue to touch the wire with the solder until it is completely coated. Tools need will be a soldering iron heat machine rosin flux solder 3M silicone dielectric grease wire s. Cover With Heat Shrink.

You should see the solder flow between the strands through the whole bundle. You should not be able to pull the bundle apart once the solder has cooled. Step 4 - Place the Two Stripped Ends Together.

Identify and Strip input Wire and output Bundle. Touch the solder with an iron tip while joining it with the header. The process will form a good solid joint.

Its not too difficult. Telegraph twist strip about 34 of an inch off of both wires place them together like an X and twist them togetherdont lay the wires side by side lay them so when your done twisting they look like a straight piece of wire this should leave you with a little less than 34 of an inch of bare wire showing twist them tight and only solder a 38 inch section or so in the. Hold it for 3-4 seconds on the wire.

Carry on with the other wire in the same manner. 1 clean the wires so they shine 2 twist the wires tightly together and steady the connection with clamps and 3 heat one end of the connection with the tip of the soldering iron. To get started use wire strippers on the wire so you have bare wire exposed.

Make seven or eight turns and cut the excess of the wire. The process for soldering 3 wires together is the same as splicing 2 4 or even 10 of them. There are three common techniques to solder wires together.