How To Restore A Soldering Iron Tip

In this case soldering iron coil wire will be turned off if it has reached a certain temperature.

How to restore a soldering iron tip. Good soldering process is important. Set the temperature of the soldering iron between 250C and 300C. Iron again which means adding a fair amount of solder and letting it.

Push the soldering iron tip into the chemical cleaner until the entire rusted area is submerged. One is a Heating Element and another is a Temperature adjustment control. First use a wet sponge to wipe off the tip before soldering.

The best tip tinner is your solder--tips should always be coated with a small amount of solder. Leave it there until the paste melts around the tip. Set the solderingdesoldering station to a temperature of 300C approximately 575F Add a flux cored wire solder that will be used in your applications or use the HAKKO FS-100 Tip Polish.

Sit for a few minutes before wiping it clean. This should leave the tip of the iron with a layer of solder on it. Wipe off the irons tip between strokes.

It took a lot of effort with tip tinnercleaning compound to make the solder wet the tip again. The flux in tip cleaner removes the oxidation and build up from the soldering iron tip and then the solder re-tins the tip ready for use. You can repair a malfunctioning soldering iron by replacing the heating element.

This will restore the soldering iron to its normal functionality. Operate at the lowest possible temperature 800F 427C or lower. Dip the tip into the tinner making sure that the entire oxidized surface is in contact with the re-tinning product.