How To Remove A Broken Headphone Jack From Ipad

Another option is to use a dab of super glue to reconnect the two broken pieces of the headphone plug.

How to remove a broken headphone jack from ipad. Insert the toothpick or paperclip into the socket until it touches the headphone jack. Turn the phone upside down to remove any metal particles. The very first thing you can do is plug in your headphone in your iPad and then unplug it after about half a minute.

Just worked and I am thrilled. If you are using the device that has the broken piece in it simply turn on the captions by clickin. Apply a little side pressure and carefully pull the burr out and the broken jack.

Now insert the melted tip of the ink tube into the headphone jack and press firmly. Let the glue set then give a pull to see if you can get it out just make sure not to slop. If the broken jack piece left in the ipad still has a small post of metal showing mine did i took a short length of wire from a piece of 103 electrical wire ground wire is bare copper took a small soldering gun as it heats up quickly put some soldering flux on the end of the copper wire heated it and put a light coating of solder on it then put a small dab of flux on the broken jack end in the ipad then.

33 out of 5 stars. Screw the sheet metal screw into the hole about 6 turns. Do not screw in excessively or risk pulling the entire receptacle out of iPad.

Hold for 2-3 minutes or until the melted plastic has thoroughly cooled. I was watching Youtube videos on my ipad when I noticed that the sound was funny. Wait for it to cool for a few minutes.

Turn off your Dremel tool and remove the burr. In the US for example service costs between US269-US419 plus US695 for shipping sales tax will. While the headphone jack works without any problems it is super annoying when it does not.