How To Properly Solder Electrical Wires

With proper soldering of wires the following operations must be performed.

How to properly solder electrical wires. Now that your wire has been properly tinned it can be soldered to the sensor the same way as the connector below. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires. This process should melt the solder and coat both wires evenly.

A cold solder joint happens when the hot solder hits a cold wire hardening it. Start with clean bright copper. How to Solder Wires Together Correctly Like a Pro.

Repeat this process on the other wire. Do not over tin the wire or solder may flow up under the wires insulation causing it become rigid or you will end up with globs of solder on the terminal that will have to be removed. Tin coat with solder the soldering tip first.

Soldering tools for electrical applications should be in the 25-30 W range. The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently. Tarnished copper is hard to solder.

Or a bit of steel wool or fine-grit sandpaper will work in a pinch. Wrap one or two inches of solder around the tip while the iron is cold. Cut the wires to the.

AND USE NON-CORROSIVE FLUX. When the Solder is melted it will automatically create a strong bond between the connector and wire. The core can be soldered in the same way.