How To Prime A Soldering Iron Tip

This should leave the tip of the iron with a layer of solder on it.

How to prime a soldering iron tip. This helps remove impurities such as remnants of solder from previous projects grease oxidation etc. Search Findchips and Save Today. Turn the solder pot on and allow it to achieve the desired temperature.

Unroll a portion of solder then roll the hot tip of the iron from the end of the solder until it does one complete turn on the solder. If not wait a bit more or add more water to the sponge if its too dry. Be sure that the soldering iron tip is held in the horizontal to the sensor with minimal movement to maximize physical contact between the middle of the working surface of the tip and the sensor.

Before soldering clean your tip with a clean cloth and some alcohol. After soldering immediately coat the tip in fresh solder. Place the soldering iron tip onto the sensor and apply solder as if you were making a solder connection.

The tip type is determined by the soldering iron it is used on. Install the prepared tip in your soldering iron. Search Findchips and Save Today.

Be careful not to over-tighten the locking nut. If it doesnt you need to remove all solder and grind the tip again more thoroughly. Alternatively you can use a special polishing bar particularly of the tip.

Clean Soldering Iron Tips. If you clean off the rust and spot a hole in the iron coating recognizable by the copper color showing through from the inside or if any part of the tip appears hollowed out its done. This is because as the soldering iron expands and contracts quickly.