How To Make A Soldering Iron At Home Easy

Adriajunyent-ferre took a pair of cheap 5 USB soldering irons and turned them into a nifty pair of SMD soldering tweezers.

How to make a soldering iron at home easy. It works on a very basic principle. Test that your unit is working correctly using your computer or wall outlet. You have successfully transformed your battery-powered soldering iron into a USB soldering iron.

I used a PVC pipe small piece of wood a Copper wire Nichrome wire for this project. Its use for heavy soldering even you can sold brass very easily. The two irons are coupled together using a simple 3D printed part.

For making this project we need some components. Touch the solder to the tip of the iron and make sure the solder flows evenly around the tip. Take a wet sponge and rub it over the top of the solder iron.

Wait a few seconds to let the tip heat up again before proceeding to step 4. Doing this first will take care of any mild buildup and help you discern in a safe way whether the tip is still too warm to touch with bare hands. Attach one end of the heater nichrome wire about 0305 mm diameter near the sharp end 3 and start winding it over the insulation to make the heater resistor 4.

You should do this by starting to heat the tip. DIY Soldering iron variant 1 Take the copper tip 1 a piece of 710 cm of 345 mm diameter copper rod and roll the insulator over it on about 4 cm. We use this heat to melt down a conductor metal also called soldering wire and putting it between two components in order to connect them electrically.

Take a piece of 34 in steel pipe about 18 in long. As you do this make sure to touch the graphite using a free wire connected to the ground. Hold the soldering iron in one hand and solder in the other.