How To Make A Soldering Gun Tip
I made sure the part of the tip that would be used for soldering was well tinned with solder this helps to protect it.
How to make a soldering gun tip. Bronze or soft steel brush. Then wrap some of this solder around the tip. However soldering guns and stations cost 2-3 times the amount of a soldering iron.
12 Copper Wire - YouTube. Clean with a wet sponge. If you already have a soldering gun you can adapt it for resistance soldering without modifying the gun itself.
In order to empty the solder sucker press down on the plunger. Looks like something Macgyver would make. Slide the retaining nut over the tip and retaining sleeve and hand tighten.
Then turn the soldering iron on and let it get to 750 degrees F and let the solder melt. I dont know about you but when the zombies start populating and theres no more HMC Electronics around to buy soldering equipment from this is the guy I want with me. To use press the plunger down at the end of the solder sucker.
With this you would be dripping melted solder onto the project. Press the release button to suck up the liquid solder. Because to solder something properly you need to make contact with the part youre soldering.
Unroll a portion of solder then roll the hot tip of the iron from the end of the solder until it does one complete turn on the solder. Therere 3 kinds of soldering tips we are supplying. Open the Soldering Iron Carefully.