How To Fix A Broken Soldering Tip
If it doesnt you need to remove all solder and grind the tip again more thoroughly.
How to fix a broken soldering tip. When done I removed tape cleaned flux off and trimmed wire to length. Then you will need to try again. The reason why its going black is because there is nothing on the tip to heat - ie.
The solder melts and should stick at the tip. If that gives you sound it means you lost connectivity while soldering the ground and you will need to heat up the solder and remove it with the solder pump or wick. Otherwise the Soldering Tip may Break.
Turn best the clutch and not the contact plug. Steps for Repairing soldering iron not heating. Allow the chain to cool pickle and clean up as needed.
What can I do to increase soldering tip life. Open the Soldering Iron Carefully. If the plug is cooled down pull out spout and the coupling to the plug replace the plastic guide and screw on the plug.
Then fully melt these pieces of plastic by pressing them with the soldering iron tip until they are liquefied. Kynar Wire is wire you need to fix a broken trace or to wire one point to another they come in many different sizes buy which ever one is suitable for your needs. An overheated joint results from solder failing to flow and the burnt flux residue can make repair very difficult.
Install the prepared tip in your soldering iron. Since the move from lead to lead-free solders a common complaint has been short tip life. How to solder a broken joint.