How To Clean Soldering Tip

You should push the soldering iron from the tip to down for cleaning.

How to clean soldering tip. Wipe OFF the solder on the Cleaning Sponge or Copper Wool. Once clean and shiny perform tinning and now your tool is ready to use. How to Tin or Re-Tin Soldering Iron Tip.

Then dip into the tin of tinner cleaner with a slight twisting action. If your soldering tip becomes detinned oxidized it can be restored in a number of ways. It hampers a neat and clean desoldering of the circuit board.

Then dip the tip in the cleaner and do a slight twist action. In order not to spend extra money on cleaners with sawdust in the box you can do it easier. You also can clean your soldering iron tip with a sponge while using it to keep it clean.

Be sure to clean the cold tip then treating it with acetone and wiping well with a cotton cloth. Wipe the iron on a damp sponge to remove the excess. Melt some good quality of solder wire on the Tip.

If the tip is hot enough normally at least 300C and relatively free of rust the solder will flow up the tip and coat it. This step will coat the iron in a mixture of flux and solder. Be careful not to over-tighten the locking nut.

Then push it on a clean sponge for cleaning. Use stainless steel wool flux and thick clothe to clean the tip. Clean the tip After every cycle and before you start to solder always clean your tip.