How To Clean Soldering Gun

With an old tip you may need to use a file to remove badly oxidized areas.

How to clean soldering gun. You clean the tip by thrusting the iron into the shaving a few times. Touch the cold flat head screwdriver to the liquid solder and quickly remove it. Work quickly carefully and as close as possible to the soldering area for best results.

You also can clean your soldering iron tip with a sponge while using it to keep it clean. Gently wipe the solder gob toward one side of the pins so that it collects on one corner. Remove the source of heat and quickly apply solder around the pipe as it seeps into the joint.

Some people are wondering why this is on hackaday its because many of us have a nice clean snicker operating table with a handy soldering gun and isopropyl alcohol ready to do fix or clean up. It is a handy suction tool that works like a vacuum. Over time soldering iron tips accumulate old solder and other debris this guide shows how best to clean the tip with a damp sponge or tip tinner cleaner.

It is commonly called a solder vacuum and sometimes solder sucker for others. This is because the metal only remains hot enough to melt the solder for a few seconds. Having a soldering iron can make removing solder from a piece of pipe or electronic circuitry much easier but it is by no means a necessary tool.

If its a new tip use sandpaper or steel wool so the metal shines. Apply the red hot screwdriver to the solder being careful not to touch the surrounding circuitry if you are removing the solder from a piece of electronic equipment. A clean and tinned soldering iron tip ensures good conduction of heat.

It can suck small amounts of solder by melting the joints. Start with a clean soldering tip. Electronix Express points out that in order to remove the dirt and debris that accumulates on the tip of a soldering iron it is necessary to wipe it clean with a sponge.