How To Clean A Soldering Iron With Flux

Techspray G3 Flux Remover.

How to clean a soldering iron with flux. Once you are ready with the flux cleaning solution know that the rest of the procedure of how to clean PCB after soldering is only a matter of time. If the tip is hot enough normally at least 300C and. If necessary trim your leads with a sharp shear lead cutter and dont trim into the solder joint.

Tinning using flux and cleaning. These cleaning agents do not have the cooling effect that the wet sponge creates. A solder pot may also be used to tin or re-tin your soldering iron tip.

Secondly heat the solder and pour on the tip of the soldering iron and clean it again. In the second step another fluid is used to rinse away the solvents leftovers. Move the sponge all around the tip and clean.

This should lead to a clean shiny tip ready for use. This should lead to a clean shiny tip ready for use for more info see this video. 3 Steps to a Clean Soldering Iron Step 1.

Cleaning the iron is usually done with either a damp sponge or brass turnings. Once the soldering process is done some flux residue is seen on the surface. Step 2- Using a brush apply flux with solder to both pieces of the terminal that need to be connected.

The flux will be activated by the heat that will start a chemical reaction to eliminate the oxidation. Heat the soldering iron and use a moist sponge to clean the surface. Step 1- When soldering two pieces it is good to use steel wool or scotch brite to remove oxide layers from the surface.