How Do You Solder Small Wires

Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires.

How do you solder small wires. You have to use leaded solder though because this will pull the enamel wire right onto the center of the pin or pad. Heat the wire not the solder. In the old days radio and television engineers utilised the 60-40 solder mix.

Then touch the tip of the soldering iron to the bottom side of the wire so the solder pool is in contact with the wire. Set the iron to the solders temperature range. Step 5 - Place the Connector Over the Ends of the Wires.

You could also twist them before soldering to increase mechanical strength. This will help conduct heat to the wire. Run the solder over the entire splice so it can melt and travel into the gaps between the wires.

How to Solder Wires. Wipe the excess off with a damp paper towel or sponge. If youre using a new soldering iron you have to tin the tip.

Begin by removing the insulation from the ends of both wires you are soldering together. You can fix it using a soldering iron as long as you follow the basic rules of soldering copper wire and make sure you. Choosing the correct solder used to be simple however today you can obtain a wide variety of solders for different tasks.

Remove both the solder and the soldering iron tip from the connection as soon as enough solder melts onto the pad. Step 6 - Twist the Connector On. To solder each connection.