How Do You Solder Electrical Wires

If this is not the case trim and re-solder the wires.

How do you solder electrical wires. Step 5 - Place the Connector Over the Ends of the Wires. Step 6 - Twist the Connector On. The center contains flux that cleans the surface of the wire to be soldered.

Apply Solder to the Wire. For small wire form a shepherds crook in each wire to link them together or twist them together pigtail splice them solder. I will be using a power probe butane soldering gun.

Step 2 - Choose the Right Size Wire Connector. This tool worked the best for me in the automotive application and make it a breeze get that tuff to reach wires repaired soldered and sealed. The broken wires can be repaired without replacing the entire harness or section.

I will show you how to solder wires together the right way to seal the solder joint with heat shrink is a must and you also need to make sure you do not have a cold solder joint. For large gauge wires 14awg for an antenna perhaps make a Western Union splice then solder it. First place the solder on the tip to allow for melting.

If desired you can clamp the wire in a third hand tool or similar heat-resistant holding device. Damaged wiring can be soldered to complete or repair an automotive electrical circuit. If so then refer to the products list above and follow these steps to successfully solder an electronic component.

The connection should not have any uneven globs of solder and the solder should penetrate both wires. If you are not soldering pipes or wires then you may be soldering electronics. Keep the iron in place and touch the solder to the wire until its fully coated.