How Do You Make Your Own Soldering Iron

If so you can do it with a normal soldering iron.

How do you make your own soldering iron. For paste apply the paste to tinned pads on a PCB place a surface-mount component on the pads and heat the assembly in an oven so that the solder melts. In the end it all boils down to what you like to use and what you are using it for. Find the Parts you Need.

Create your sandwich being very careful with the leads they break easy. Its easy to make your own iron on transfers using free clip art or a favorite photograph and special transfer paper you run through your inkjet printer. Apply some solder to the tip of your iron and touch the circuit board pad with the tip so that some of the solder passes on to the pad.

The flux cleans the pad and makes it easier for the solder to fasten properly. I just slide a blade in to pry it open a little and slide a new one in. If TSA gives the okay and says that you are allowed to travel with the soldering iron the next step you want to make is to contact the airline you will be going with.

Apply lots of solder to one side of the resistor then quickly melt the other side and flick it off. Use the small needle tip bottles to apply the flux to your projects. All you need to make an iron on transfer is a photo or large clip art picture a color printer and plenty of ink a word processing program or graphics editing program a package of iron on transfer paper.

When you are comfortable with a ratio scale it up and mix a large batch in the glass jar. If you can only get lead-free solder where you live its OK but please dont breathe in the nasty smoke. If you see any solder splashes after just flick it off with you finger nail not the soldering iron.

This soldering station has almost identical features to the Weller WLC100 but is also bundled with a roll of solder a solder sucker and a selection of different tips. Direct the tip of the flames blue cone toward the metal pieces and move the iron around the area surrounding the seam until the solder changes color and fills the seam. The box should be as wide and as long as the iron that it will hold.