Can I Use A Nail As A Soldering Iron Tip

Only use this device when the tip is cold as using it with a hot tip can damage the tip.

Can i use a nail as a soldering iron tip. And yes tin whiskers might be a. If youre doing mostly through hole components the ETA is perfectly fine. Use acid-core solder only on galvanized iron and other hard-to-solder metals.

You can in fact solder a 04mm pitch TQFP with a tip that spans several pins such as the ETA you mention but it takes a lot more skill and flux. If theres a stubborn piece of contaminant left on the tip you can use. I figure it would work just like an electric domeless nail.

Ad Wholesale Mobile Accessories Parts Electronics With 12 years Experienced Supplier. This helps remove impurities such as remnants of solder from previous projects grease oxidation etc. While the soldering iron is at full temperature roll it in the tip tinner.

Take some pliers to tighten the windings. Wipe the iron on a damp sponge to remove the excess. If you do not keep your soldering tip cleaned and properly maintained then it will not be able to heat up the solder enough to get the job done.

Regarding chipquick - thats a nasty stuff - you have to clean it off as much you can otherwise it will mess up the melting point of the solder and will make the solder joints brittle. If youre an expert solderer in a pinch for a small joint probably yes. Install the prepared tip in your soldering iron.

Once you do that you put a dab of your concentrate onto a domeless nail and touch the heated soldering iron tip to it to vaporize it. As you roll it it should change from black to shiny silver as the baked flux is cleaned off. Those nails are tough if they can punch 3 into concrete.